A. Check the hopper to ensure it contains dry Barbeque grade pellets in the grill.
Always start the grill with the control knob set at the start position.
If this is the initial startup of the grill, it will take a few extra minutes to ignite, as the auger itself fills with pellets.
The Auger is not turning.
Check for pellets or other material jamming the auger. Clean out the entire hopper and the auger shaft assembly.
Please go to our web site www.SawtoothPelletGrills.com for instructional videos on how remove the auger motor and shaft.
After reassembling the auger assembly. Start the grill following the standard ignition steps and verify the auger shaft is turning. If the Auger shaft does not turn after cleaning.
A. Confirm that the blue light on the control panel turns on when the start button is pushed. If the blue light does not appear:
A. Many users cook year round with their smoker. In warmer weather your grill is designed to easily reach 150+degrees in a minimum of 30 minutes. As a safety feature your grill is designed to shut down and give an ER-2 error on the display if it is not able to accomplish this. In colder climates this can be a challenge as temperatures start dropping below 40F.
By following these simple instructions you will be able to enjoy the use of your grill year round regardless of the weather.
From a cold start:
From this point the grill will be able to reach the desired cooking temperature regardless of the weather. It should be noted that it will take more time to reach set temps in colder weather and pellet usage will be higher.
A. Remove the rear panel of the Hopper and check to make sure both wires are plugged into the fan. Un-plug each wire one at a time and verify they are corrosion free and reattach them. (If there is corrosion on the plug clean it with a piece of 80 grit sand paper and apply electrical connector grease to the tab.)
Run through the start up sequence again to see if the fan works. If the fan still does not work.
A. Calibration of your Thermometer
Place the thermometer into boiling water. (The thermometer should read 212 degrees.)Grease and debris can build up on the probe and prevent it from reading accurately.
Turn the adjustment screw on the back of the thermometer to increase/decrease the temperature to 212.
Clean the probe with soapy warm water and try the thermometer again.Please contact your local dealer for further assistance in ordering replacement parts.
A. Inspect your power cord for frays, cracks, melting insulation or sever crimps.
(If any of these signs are present do not use your grill!)
Contact your local dealer immediately for assistance in ordering a replacement Power Cord.
If plugged in to a GFI outlet make sure the breaker in the outlet is set.
Unplug the grill.
Remove the back of the Hopper.If none of these steps resolve the problem a new control panel is needed. Please contact your local dealer for further assistance in ordering replacement parts.
Check connections for corrosion and reconnect them. (If there is corrosion on the plug clean it with a piece of 80 grit sand paper and apply electrical connector grease to the tab.)
Run through the start up sequence.
Make sure all of the plugs on the back of the Control Panel are plugged in and corrosion free.
A. Check the pellets in the Hopper to make sure they are not damp. Unplug the unit and let it completely cool down Remove the grill grates, grease pan, fire shroud and clean out the burn pot. Then restart the grill.
A. Purchase a grill cover. Do not leave your grill uncovered. Follow the initial set up instructions, found in the User’s Manual.
A. Please contact your local dealer for further assistance in ordering replacement parts and accessories. For a dealer locator go to www.Sawtoothpelletgrills.com and enter your zip code.
A. Yes, Please go to www.Sawtoothpelletgrills.com Auger Shaft – cleaning and replacement Auger Motor - cleaning and replacement Fan – cleaning and replacement Control panel – cleaning and replacement Assembly Video Initial set up Video Cleaning Video.